Structured Wiring Panel Wall Enclosure 29"
CON2029IN Structured Wiring Panel Wall Enclosure 29" x 14-1/4"
These heavy duty Structured Wiring Enclosures are decked out Complete with knock-outs and removable rubber grommets, a removable locking door that can swap sides for convenient open swinging action, and polished off with a powder coated finish. Wire Enclosure come with removable locking doors. Surface-Mounting is painless with easy access rear-mounted support slots for wall anchors. You can easily install this enclosure in a recessed wall using the depth markers located on the side of the box. These depth indicators make installing to any wall surface between 1/2in and 3/4in thick effortless. Module mounting holes are standard / universal with cable tie slots to manage all the different cables inside. They have 1 Electrical / High Voltage knock-out and 20 round knock-outs, 8 of which have rubber grommets pre-installed.
Though Structured Cable Products and Home Network Wiring is Bundled Together for Economy in Space and Ease of Installation, the Component Cables and Wires should still be treated as Individual with the Systems to which they belong as compared to the Whole. No One System should be Sacrificed to serve the Needs of Another. When Preparing Terminations, Leave Plenty of Tail before Prep, and Plenty of Spare to Coil after. This will Serve Future Expansion Well. Most Manufacturers know the limitations of the Individual Wires and Cables their are Bundling, Make Sure you do too. It is Especially Important to Approach Installation as the Most Fragile of Companents as the Major Consideration. Do not Force the Issue, If It doesn't fit, Be patient enough to Figure a Work-Around. A properly prepared Communications PVC Conduit route involves sweeps, not 90 Degree bends, and as few as possible. The size of the conduit should be 4 times that to be occupied. Install with MuleTape already inside for ease of pull-through. Do not under any circumstances colocate communications circuits with power. Even in Conduit, power circuits and routings should be crossed at 90 angles of intersect as to avoid field induction. If your routing has to be parallel, consider 2 feet to be minimum distance if either is shielded, 4 to 6 feet if not. Comm circuits should avoid flourescent lighting at all costs... The fields generated from the ballast transformer and even the bulb will wreak havoc on todays micro-circuits.
There are Panel Box Systems made for central inter-connection of Video, Telco, Internet and Intercom. Regardless of manufacture, they are pretty much standardized in the block-out of space inside, and the installation of the Modular blocks of Termination and patching. Again, AC power for the systems should remain outside the panel, with either the transformers plugged into the outlet and DC running through the bulhead inside the Panel, or the standard AC plug running through a bulk-head to the outlet outside the Panel.
Sorry, we are offline,
click here to send us message
