Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

180 Degree Hardline Extended Adapter 4.5"

Price$12.95
Manufacturer CodeCPPA1804.5
Qty
AvailabilityUsually ships in 24 Hrs

Highlights

75 Ohms

0 Mhz to 1 Ghz

180 Degree Adapter

4.5 inch

Bulk Quantities Available Here!

PPC CPPA1804.5 180 degree Hardline Cable adapter 4.5 inch

 

180 degree extended adapter with set screw is designed for installations where space restrictions require nonaxial connections between cables and equipment. All adapters come standard with 2.15” length entry pins, weather-sealed joints and allow for entry of a .155 diameter center conductor , bandwidth 0 Mhz to 1 Ghz. , 75 Ohms

 

Note : Image provided for representation purposes only

Note

 

INSTALLATION INSTRUCTIONS CPPA1804.5 1.

 

Loosen the equipment seizure screws. 2. Measure and trim the pin of the 180 Degree Adapter according to equipment manufacturer’s specification. 3. Thread the 180 Degree Adapter into the equipment housing approximately 3 1/2 turns. 4. Remove the cap of the 180 degree adapter and loosen seizure screw. 5. Trim the pin of the connector to 9/16” as shown below in the diagram. 6. Hand tighten the pin connector into the 180 Degree Adapter. Wrench tighten an additional 1/8 to ¼ turns while holding the adapter with another wrench. 7. Install the prepared cable into the pin connector and fully tighten per the connector installation instructions. 8. Finger tighten the seizure screw to the connector pin within the adapter, then tighten an additional 1/8 to ¼ turn with a screw driver or nut driver. 9. Hand tighten the jam nut of the 180 Degree Adapter to the equipment housing while holding the connector in position, then further tighten the jam nut with a wrench an additional 1/8 to ¼ turns. 10. Hand tighten the jam nut between the 90 degree blocks, then further tighten 1/8 to ¼ turns with a wrench.

3 Star Inc stocks a full range of quality Hardline Coaxial Cable Connectors in two and three piece designs. We supply trunk and Distribution connectors in a variety of sizes to fit any size cable as well as various types of adapters for all your HFC design requirements. The majority of our inventory consists of NEW connectors that are in the original box from the manufacturer and are available for immediate shipment. With prices considerably lower than other suppliers, it doesn't make sense to buy anywhere else.

 

Amphenol, Gilbert, PPC, Thomas & Betts/LRC
Call or email for pricing
(804) 550-7202 | info@3starinc.com


Gilbert
Gilbert


Check Availability




Gilbert
LRC


Check Availability




Gilbert
PPC


Check Availability



Products   Recently Viewed